Cirrus-logic CS8406 User Manual Page 12

  • Download
  • Add to my manuals
  • Print
  • Page
    / 39
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 11
12 DS580F6
CS8406
4. THREE-WIRE SERIAL INPUT AUDIO PORT
A 3-wire serial audio input port is provided. The interface format can be adjusted to suit the attached device through
the control registers. The following parameters are adjustable:
Master or slave
Serial clock frequency
Audio data resolution
Left or right justification of the data relative to left/right clock
Optional one-bit cell delay of the first data bit
Polarity of the bit clock
Polarity of the left/right clock (by setting the appropriate control bits, many formats are possible.)
Figure 7 shows a selection of common input formats with the corresponding control bit settings.
In Master Mode, the left/right clock and the serial bit clock are outputs, derived from the OMCK input pin master
clock.
In Slave Mode, the left/right clock and the serial bit clock are inputs. The left/right clock must be synchronous to the
OMCK master clock, but the serial bit clock can be asynchronous and discontinuous if required. The left/right clock
should be continuous, but the duty cycle can be less than the specified typical value of 50% if enough serial clocks
are present in each phase to clock all the data bits.
ILRCK
ISCLK
SDIN
2
Left
Justified
(In)
MSB
LSB
Left Right
MSB
I S
(In)
Right
Justified
(In)
MSB LSB MSB LSB MSB
Left
Right
MSB
LSB
MSB LSB
Left
Right
LSB
MSB LSB
ILRCK
ISCLK
SDIN
ILRCK
ISCLK
SDIN
Figure 7. Serial Audio Input Example Formats
X = don’t care to match format, but does need to be set to the desired setting
+ I²S can accept an arbitrary number of bits, determined by the number of ISCLK cycles
* See Serial Input Port Data Format Register Bit Descriptions for an explanation of the meaning of each bit
SIMS* SISF* SIRES[1:0]* SIJUST* SIDEL* SISPOL* SILRPOL*
Left Justified X X 00+ 0 0 0 0
I²S XX00+0101
Right Justified X X XX 1 0 0 0
Page view 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 38 39

Comments to this Manuals

No comments